OKY2014: Esplora for Arduino
OKY2014: Esplora for Arduino
Arduino DIY is used for toys and science kits for kids, and steam kits for high school, primary school, and secondary school.
Additional information
| Controller | Atmega32U4 |
|---|---|
| SRAM | 2.5KB |
| EEPROM | 1KB |
| Operating Voltage | 5V |
| Clock Speed | 16MHz |
| Flash Memory | 32KB (4KB used by bootloader) |
| Weight | 210g |
Related Products
OKY8003: SG90 180 Degrees 9G Micro Servo Motor Tower Pro
OKY8003: SG90 180 Degrees 9G Micro Servo Motor Tower Pro
OKY8003: SG90 180 Degrees 9G Micro Servo Motor Tower Pro
OKY8003: SG90 180 Degrees 9G Micro Servo Motor Tower ProWeight: 9g
Size: 23mm x 12.2mm x 29mm
No-load Operating Speed: 0.12 seconds/60° (4.8V); 0.10 seconds/60° (6.0V)
Torque: 1.6kg (4.8V)
Operating Temperature: -30°C to +60°C
Dead Zone Settings: 5 microseconds
Operating Voltage: 3.5V ~ 6V
Cable Length: 25cm
OKY3432-1: PS2 Game Joystick Axis Sensor Module for Arduino AVR PIC
OKY3432-1: PS2 Game Joystick Axis Sensor Module for Arduino AVR PIC
OKY3432-1: PS2 Game Joystick Axis Sensor Module for Arduino AVR PIC
OKY3432-1: PS2 Game Joystick Axis Sensor Module for Arduino AVR PICX, Y-axis output for the 2 potentiometer, you can read through the AD conversion twist angle.
Press the joystick down, you can send all the way to touch the switch, for the digital output, has been pulled.
Applicable to two-degree-of-freedom steering gear PTZ control or other remote control proportional control.
On-board two rocker modules, suitable for mobile platform control board development and experiment.
OKY3436: Rain Detection Module Moisture for Arduino STM32
OKY3436: Rain Detection Module Moisture for Arduino STM32
OKY3436: Rain Detection Module Moisture for Arduino STM32
OKY3436: Rain Detection Module Moisture for Arduino STM32LED lamp power light, the output signal. TTL level output, TTL output signal for low level effectively.
Ability to drive about 100ma, can be directly driven relay, buzzer. small fan, and so on.
Sensitivity can be adjusted through the potentiometer.
Raindrops board and control board are separated, convenient to wire leads.
The raindrops plates of large area, more conductive to detect the rain.
OKY4016: 2.8 Inch Screen for Raspberry Pi
OKY4016: 2.8 Inch Screen for Raspberry PiThis product is compatible with Raspberry Pi paragraphs B+ motherboard and Raspberry Pi B motherboard. B+ insert method to insert method compatible with B, B+ 1 foot GPIO, corresponding paragraph B GPIO1 foot.
Reviews
There are no reviews yet.