OKY3397: Coin Cell Battery Holder for LilyPad CR2032
OKY3397: Coin Cell Battery Holder for LilyPad CR2032
This Coin Cell Battery Holder has a small slide installed on the board, in-line with the power so you can shut off your project and save batteries. This slide switch is the same as is found on the slide switch board, so it’s not easy to accidentally turn off or on.
Just like the original Coin Cell Battery Holder, this simple board holds a 20mm coin cell battery (such as a CR2032) and gives you 4 connection points (2 positive and 2 negative) for sewing into your project.
Related Products
OKY3001: SD Card Reader Module
OKY3001: SD Card Reader ModuleSD Card Module Slot Socket Reader for ARM MCU NEW
This SD Card module can make your SD application simpler and easier
Easily interfaced as a peripheral to your sensor shield module
Read and write into the SD Card using your product through programming
Can be easily used for SD Card MCU/ARM system control such as for MP3 Players
All SD SPI pins output, MOSI, SCK, MISO and CS
Supports 5V/3.3V input
OKY3422: 8 Channel Capacitive Touch Button Switch Module TTP226 for Arduino
OKY3422: 8 Channel Capacitive Touch Button Switch Module TTP226 for Arduino
OKY3422: 8 Channel Capacitive Touch Button Switch Module TTP226 for Arduino
OKY3422: 8 Channel Capacitive Touch Button Switch Module TTP226 for ArduinoOn-board TTP226 capacitive 8-button touch-sensing IC.
On-board 8-channel level status indicator.
The module can set the output, key output mode, maximum output time and fast/low power selection.
OKY3513: New Tracking Module / Tracking Sensor TCRT5000
OKY3513: New Tracking Module / Tracking Sensor TCRT5000
OKY3513: New Tracking Module / Tracking Sensor TCRT5000
OKY3513: New Tracking Module / Tracking Sensor TCRT5000Adopts TCRT5000 photoelectric sensor and comparator
Easy to use, good stability and anti-interference ability
Perfect for black and white line detection for smart car
Black line for low level output, white line for high level output
OKY3436: Rain Detection Module Moisture for Arduino STM32
OKY3436: Rain Detection Module Moisture for Arduino STM32
OKY3436: Rain Detection Module Moisture for Arduino STM32
OKY3436: Rain Detection Module Moisture for Arduino STM32LED lamp power light, the output signal. TTL level output, TTL output signal for low level effectively.
Ability to drive about 100ma, can be directly driven relay, buzzer. small fan, and so on.
Sensitivity can be adjusted through the potentiometer.
Raindrops board and control board are separated, convenient to wire leads.
The raindrops plates of large area, more conductive to detect the rain.
Reviews
There are no reviews yet.